EasyManuals Logo

Geeetech Rostock 301 User Manual

Geeetech Rostock 301
79 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
SHENZHEN GETECH TECHNOLOGY CO,.LTD
20
5.1.2 Heating Test
Click the heating button of the hot bed and the extruder . When the slash disappeared as
shown below, it indicates the heating is ongoing and you can see the number rising up.
Meanwhile you can see the temperature at the bottom status bar of Repetier Host. If the number has no
change or obviousely abnormal, e.g. above 300, please refer to this post.
5.1.3 Extruder test
Please note: It is set in the firmware that the extruder will not work until the temperature reaches above
170. Therefore, please heat up the extruder above 200 before testing the extruder. Otherwise the
extruder motor will not have any response.

Other manuals for Geeetech Rostock 301

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Geeetech Rostock 301 and is the answer not in the manual?

Geeetech Rostock 301 Specifications

General IconGeneral
BrandGeeetech
ModelRostock 301
Category3D Printers
LanguageEnglish

Related product manuals