Geeetech Rostock 301 User Manual

SHENZHEN GETECH TECHNOLOGY CO,.LTD
31
Move the nozzle to the other front screw and adjust the screw until you get the same amount of friction as
you felt with the first one. Then adjust the back screw the same way.
Once you have adjusted each of the three screws, go back and check each one again, since adjusting one
screw can affect another. You shouldn’t need to go around the bed more than twice.
The proper printing effect of the first layer is like following picture:

Geeetech Rostock 301 Specifications

General

Brand	Geeetech
Model	Rostock 301
Category	3D Printers
Language	English