SHENZHEN GETECH TECHNOLOGY CO,.LTD
2. According to the work principle of Mixer, the sum feeding rate of Filament0 and Filament1 is 100%. After
Filament0 is set, the system will automatically calculate the corresponding feeding rate of Filament1.
3. Start percent and end percent can be set at will. The sum of them is not always 100%. Users can adjust it
according to their requirements.
E.g., you can set the start percent of Filament0 as 30% and the end percent 60%.
4. Start height and end height are print heights above the bed not the current printing height. Start height and
end height must be greater than current printing height; otherwise they will be regarded as invalid.
For example:
Current height is 40mm above the bed, but the start height in the template setting is 20mm and the end
height is 30mm. It has overlapped part with current print height, so the system will automatically ignore this
template and continue printing with the current template.
5. When one template is finished, printing will continue with the feed rate percent that is fixed, without
gradient effect, until you choose a new template.
9.3.2 Custom Template Setting
Choose Mixer->Custom on LCD control panel:
To Next Page
Loading...
Need help?
General
