5.9.4 Delete the Entire Redial List
Using the handset:
1. Follow Steps 1 and 2 in section 5.9.1.
2. Press LEFT SOFTKEY and / to select DELETE ALL.
3. Press LEFT SOFTKEY to confirm.
4. Press LEFT SOFTKEY to reconfirm.
5.10 Find the Handset
This feature helps you find the misplaced handset(s).
You can locate the handset by operation on the base station as below.
• In idle mode, press /HANDSET LOCATOR.
All the handsets registered to the base will produce the paging tone, and “PAGING” will
flash on the screen. You can stop the paging by pressing / / /
RIGHT SOFTKEY on any handset or /HANDSET LOCATOR on the base to stop
paging. On the alarm pendant press the SOS key to stop the paging.
NOTE:
If there is an incoming call during paging, the phone or the Alarm pendant will ring
with the incoming call instead of paging.
5.11 Make an Internal Call
This feature allows you to make internal calls, transfer external calls and make
conference calls. If the called handset is not answered within 60 seconds, it will stop
ringing and the calling one will return to standby mode.
5.11.1 Intercom
Using the handset:
1. In idle mode, press LEFT SOFTKEY
and the numbers of the registered
handsets will display except the calling handset.
2.
Enter the desired handset or pendant number you want to intercom with.
3. The called handset rings. Press or on the called handset to establish the
internal call.
NOTE:
If only one cordless handset is registered to the base station, internal call will not be
available.
Note:
It is not possible with the pendant to intercom one handset.
To Next Page
Loading...