8.4.4 Set the Dial Mode
The default dial mode is best suitable for your country and network operator. It is
unlikely that you should need to change this setting unless advised to do so.
1. Press LEFT SOFTKEY and / to select BS SETTINGS.
2. Press LEFT SOFTKEY and / to select DIAL MODE.
3. Press LEFT SOFTKEY and / to select your desired dial mode
(TONE or PULSE).
4. Press LEFT SOFTKEY to confirm.
8.4.5 Set the Flash Time
The default flash time is best suitable for your country and network operator. It is
unlikely that you should need to change this setting unless advised to do so.
1. Press LEFT SOFTKEY and / to select BS SETTINGS.
2. Press LEFT SOFTKEY and / to select FLASH TIME.
3. Press LEFT SOFTKEY and / to select your desired flash time (SHORT
=100ms, MEDIUM=300ms, LONG=600ms).
4. Press LEFT SOFTKEY to confirm.
8.4.6 Change the System PIN Code
A 4-digit system PIN code is used for changing the system settings of the base
station. It is used to protect your phone against unauthorized use. The default system
PIN is 0000.
1. Press LEFT SOFTKEY and / to select BS SETTINGS.
2. Press LEFT SOFTKEY and / to select CHANGE PIN.
3. Press LEFT SOFTKEY and you are requested to enter the 4-digit
system PIN.
4. Enter the old system PIN.
5. Press LEFT SOFTKEY and enter the new system PIN.
6. Press LEFT SOFTKEY and enter the new system PIN again.
NOTE:
If the new PIN entered in Step 6 is not matched with the new system PIN entered in
Step 5, user is requested to enter the valid system PIN again in Step 5.
7. Press LEFT SOFTKEY to confirm the setting.
To Next Page
Loading...