5
1 Infrared (I/R) Sensor
This receiver will communicate with the included RMT-HD-DSP-IR remote
control. Proper line-of-sight must be preserved between the remote and I/R
sensor at all times.
2 Emergency Recovery Button
Use this button to reboot the DSP when the fi rmware application has become
unstable.
3 Reset Button
This button can be used to preform a hardware reset.
4 Power On Console LED
When power is applied to the unit, this LED will light red.
5 Link LED
When This blue LED will indicate the presence of a network link showing a
connection.
6 HDD Activity LED
When data is being read from or written to the internal hard drive, this blue LED
will become active.
7 Device Status LED
When the device is working normally, this blue LED will be unlit. During
Emergency Recovery mode or a fi rmware update, the LED will become active.
8 HDMI Output Port
This port will accept a single HDMI device. Both audio and video are supported
on this connector type.
9 VGA Output Port
This port will accept a single Standard VGA (Video Graphics Array) device. Only
video is supported on this connector type.
10 Analog Audio Output Port
Stereo analog audio is output via this 3.5mm mini-jack port. This connector is
active at all times.
11 10/100 Ethernet Connector
This port is used for the connection to a standard TCP/IP network. A network
connection between this unit and the server management PC in necessary for
remote management.
12 USB 2.0 Port
Standard USB interface for uploading content and fi rmware.
13 12V DC Power Receptacle
Connect the included 12V DC power supply to this input.
PANEL DESCRIPTIONS
To Next Page
Loading...
