51
4.4.21. OUT4.S - Number of switchings output 3
Acronym Scrolling message Submenu Attributes
OUT4.S NUMBER X 1000 RELAY CYCLES INFO R
If output 4 is available on the controller, the parameter shows the number of switchings (in thousands).
Unit of measurement: Number (× 1000)
Options: -
4.4.22. T.DAYS - Total working days
Acronym Scrolling message Submenu Attributes
T.DAYS TOTAL DAYS OF OPERATION INFO R
The parameter shows total number of working days of the controller since first power-on. Each working day equals 24
hours of actual functioning.
Unit of measurement: Day
Options: 0...9999
4.4.23. P.DAYS - Partial working days
Acronym Scrolling message Submenu Attributes
P.DAYS PARTIAL DAYS OF OPERATION INFO R
The parameter shows the number of working days of the controller since the last counter reset, Each working day equals
24 hours of actual functioning.
The counter can be reset with the Us.cal function.
Unit of measurement: Day
Options: 0...9999
4.4.24. T.INT - Internal temperature of controller
Acronym Scrolling message Submenu Attributes
T.INT INTERNAL TEMPERATURE INFO R
The parameter shows the instantaneous internal temperature of the controller.
Unit of measurement: °C
Options: -
4.4.25. T.MIN - Minimum internal temperature of the controller
Acronym Scrolling message Submenu Attributes
T.MIN MIN INTERNAL TEMPERATURE INFO R
The parameter shows the minimum internal temperature of the controller measured during work.
Unit of measurement: °C
Options: -
4. CONFIGURATION
To Next Page
Loading...
Need help?
General
