gefran AFE200 Series

AFE200 • Instruction Manual 3
Table of contents
Information about this manual ................................................. 2
1 - Safety Precautions ............................................................... 6
1.1 Symbols used in the manual .................................................................................... 6
1.2 Safety precaution...................................................................................................... 7
1.3 General warnings ..................................................................................................... 7
1.4 Instruction for compliance with UL Mark (UL requirements), U.S. and Canadian
electrical codes ............................................................................................................... 9
2 - Introduction to the product ................................................ 11
2.1 Drive type designation ............................................................................................ 12
2.1.1 Parallel inverters ....................................................................................................13
3 - Transport and storage ........................................................ 14
3.1 General ................................................................................................................... 14
3.2 Permissible Environmental Conditions ................................................................... 15
4 - Mechanical installation ...................................................... 16
4.1 Inclination and mounting clearance ........................................................................ 16
4.2 Fastening positions................................................................................................. 17
5 - Wiring Procedure ................................................................ 21
5.1 Power section ......................................................................................................... 24
5.1.1 Cable Cross Section ..............................................................................................24
5.1.2 EMC guide line ......................................................................................................25
5.1.3 Block diagram power section ................................................................................27
5.1.4 Power line connection ...........................................................................................28
5.1.5 DC output connection ............................................................................................30
5.1.6 Connection of fans power suplly ...........................................................................32
5.2 Regulation section .................................................................................................. 33
5.2.1 Removing the terminal cover .................................................................................33
5.2.2 Cable Cross Section ..............................................................................................33
5.2.3 Regulation section connection ..............................................................................33
5.2.4 Switches, jumpers and LED ..................................................................................35
5.3 Serial interface (XS connector)............................................................................... 38
5.3.1 Drive / RS 485 Port (not insulated) point-to-point connection ...............................38
5.3.2 Drive / RS485 port point-to-point connection (with insulation) ..............................40
5.3.3 RS 485 multi-drop connection ...............................................................................40
5.4 Typical connection diagrams .................................................................................. 41
5.5 Pre-charge kit ......................................................................................................... 43
5.5.1 Fuses for the “Voltage sense” connection (F2) .....................................................44
5.5.2 Pre-charge kit dimensions .....................................................................................45
6 - Use of the keypad ............................................................... 48
6.1 Description.............................................................................................................. 48
6.2 Navigation............................................................................................................... 49
6.2.1 Scanning of the rst and second level menus .......................................................49
6.2.2 Display of a parameter ..........................................................................................49
6.2.3 Scanning of the parameters .................................................................................50
6.2.4 List of the last parameters modied ......................................................................50
6.2.5 “Goto parameter” function .....................................................................................50
6.3 Parameter modication........................................................................................... 51
6.4 How to save parameters......................................................................................... 52