gefran AFE200 Series

AFE200 • Instruction Manual 51
of the parameter (PAR).
When the parameter reached by the “Goto” command is displayed, it is possible
to navigate all the parameters forming part of the same group using the ▲ and ▼
keys.
Pressing the ► key returns to the “Goto” function.
To exit the “Goto” function, press the ► key.
6.3 Parameter modication
To enter parameter modication mode, press the E key when the parameter to be
modied is displayed.
To save the value of the parameter, following modication, press the E key again.
Note ! To save permanently, see paragraph 6.4.
To exit from modication mode without saving the value, press the ESC key.
The operations to be carried out to modify the value depend on the type of the
parameter, as described below.
Note ! For further information about the type of parameters displayed, see chapter 8.
● Numeric parameters
T+ T- EN LOC ILim n:0 AL
01 MONITOR
02 DRIVE INFO
03 STARTUP WIZARD
04 DRIVE CONFIG
E
T+ T- EN LOC ILim n:0 AL
0 4 . 0 3
PA R : 1 2 0
In
p
ut inductance
0.7150 mH
Def: 0.715
T+ T- EN LOC ILim n:0 AL
0 4 . 0 3
PA R : 1 2 0
In
p
ut inductance
Def: 0.715
00000.7150
X 3
mH
When E is pressed to access modication mode, the cursor is activated on the
digit corresponding to the unit.
Using the ◄ and ► keys, the cursor can be moved to all the digits, including trail-
ing zeros that are normally not displayed.
With the ▲ and ▼ keys, the digit under the cursor is increased or decreased.
Press E to conrm the modication or ESC to cancel.
● Binary parameters (BIT type)
The parameter may assume only two states which are indicated as OFF-ON or
0-1.
X 5
T+ T- EN LOC ILim n:0 AL
05 REFERENCE
06 COMMANDS
07 DIGITAL INPUTS
08 DIGITAL OUTPUTS
E
T+ T- EN LOC ILim n:0 AL
0 8 . 0 5
PA R : 1 3 3 0
Di
g
out 1 inversion
ON
T+ T- EN LOC ILim n:0 AL
0 8 . 0 5
PA R : 1 3 3 0
Di
g
out 1 inversion
OFF
Pressing E, modication mode is activated. The entire line is displayed in reverse.
Use the ▲ and ▼ keys to move from one state to another.
Press E to conrm the modication or ESC to cancel.