gefran AFE200 Series

AFE200 • Instruction Manual 49
LED’s meaning:
T+ the LED is lit, when the drive operates with a positive torque
T- the LED is lit, when the drive operates with a negative torque
EN the LED is lit, when the drive is enabled
LOC The led is lit when the drive is in local mode and OFF when in remote
mode.
Ilim the LED is lit, when the drive operates at a current limit. During normal
functioning, this led is OFF.
n=0 The LED stays on.
AL the LED is lit; it signals a trip.
6.2 Navigation
6.2.1 Scanning of the rst and second level menus
T+ T- EN LOC ILim n:0 AL
01 MONITOR
02 DRIVE INFO
03 STARTUP WIZARD
04 DRIVE CONFIG
T+ T- EN LOC ILim n:0 AL
18 SERVICE
01 MONITOR
02 DRIVE INFO
03 STARTUP WIZARD
T+ T- EN LOC ILim n:0 AL
01 MONITOR
02 DRIVE INFO
03 STARTUP WIZARD
04 DRIVE CONFIG
T+ T- EN LOC ILim n:0 AL
13.1 DOUBLE PAR SET
13.2 COMPARE
13.3 PADS
T+ T- EN LOC ILim n:0 AL
13 FUNCTIONS
14 COMMUNICATION
15 ALARM CONFIG
16 ALARM LOG
1st level 2nd level
(*)
(*) This example is visible only in Export mode (see paragraph 6.5.2).
6.2.2 Display of a parameter
T+ T- EN LOC ILim n:0 ALT+ T- EN LOC ILim n:0 AL T+ T- EN LOC ILim n:0 AL
2
0 8 . 0 5
PA R : 1 3 3 0
Di
g
out 1 inversion
0 4 . 0 4
PA R : 4 5 8
DC link ca
p
acitor
3400 uF
0 5 . 0 5
PA R : 6 0 8
DC volta
g
e ref src
Di
g
DC volta
g
e ref
1
3
4
Def: 3400
A B C
T+ T- EN LOC ILim n:0 ALT+ T- EN LOC ILim n:0 AL T+ T- EN LOC ILim n:0 AL
2
0 4 . 0 1
PA R : 5 5 0
Save arameters
p
0 4 . 0 9
PA R : 5 5 2
Mains fre
q
uenc
y
50 Hz
0 1 . 0 1
PA R : 2 5 0
Out
p
ut current
+
0. 3
A
1
3
4
Value: 0
D E F
ON
Value: 600
Press E to execute
Param read onl
y
T+ T- EN LOC ILim n:0 AL
2
Autotune
1
3
4
Error code: 1
G
Press ESC to exit
1 Position of the parameter in the menu structure (in gure A, 16.01);
number of the parameter (in gure A, PAR: 458).
2 Description of the parameter.