38 VDL200 • Quick installation guide - Specifications and connection
8.2.3 Scanning of the parameters
01 MONITOR
02 DRIVE INFO
03 STARTUP WIZARD
04 DRIVE CONFIG
05 LIFT
01 MONITOR
01/20 PAR: 250
Output current
0.0 A
0%
01 MONITOR
20/20 PAR: 1400
Di
g
ital output X mon
00000000010001
01 MONITOR
02/20 PAR: 252
Output voltage
0 V
0%
8.2.4
Pressing the CUST
8.2.5 "FIND" function
Pressing the FIND key activates the function that makes it possible to access any parameter simply by entering the
parameter software number (PAR).
When the parameter reached by the "FIND" command is displayed, it is possible to navigate all the parameters forming
FIND
8.2.6
E
E key again.
Note! To save permanently, see paragraph 8.2.7.
ESC key.
The operations to be carried out to modify the value depend on the type of the parameter, as described below.
Note! For further information about the type of parameters displayed, see paragraph 8.2.2.
Numeric parameters
14 MOTOR DATA
15 ENCODER CONFIG
16 SPEED REG GAINS
17 REGULATOR PARAM
18 TORQUE CONFIG
14 MOTOR DATA
01/26 PAR: 2000
Rated voltage
400 V
Def: 400
E
14 MOTOR DATA
01/26 PAR: 2000
Rated voltage
0000004000 v
Def: 400
When E
displayed.
Press EESC to cancel.
Binary parameters (BIT type)
The parameter may assume only two states which are indicated as On-or 0-1.
11 DIGITAL OUTPUTS
14 MOTOR DATA
15 ENCODER CONFIG
16 SPEED REG GAINS
17 REGULATOR PARAM
x8
11
DIGITAL OUTPUTS
09/16 PAR: 1430
Di
g
out 1X inversion
O
f
f
E
11
DIGITAL OUTPUTS
09/16 PAR: 1430
Di
g
out 1X inversion
O
f
f
11
DIGITAL OUTPUTS
09/16 PAR: 1430
Di
g
out 1X inversion
On
Press E
state to another. Press EESC to cancel.
To Next Page
Loading...
