913225/CP0807 18 PRINTED IN U.S.A.
 Some illustrations used in this manual may show
doors, guards and shields open or removed for
illustration purposes ONLY. BE SURE that all
doors, guards and shields are in their proper oper-
ating positions before starting the engine.
 For the safety of the operator and others, do not
change the structure or settings of the various com-
ponents used in the telescopic handler (hydraulic
pressure, calibrating limits, engine speed, addition
of extra equipment, addition of counterweight,
unapproved attachments, alarm systems, etc.). In
this event, the manufacturer cannot be held respon-
sible.
 The operator must keep the telescopic handler
properly cleaned.
 Read the operator's manual carefully.
 The operator's manual must always be in good
condition and in the place provided for it on the
telescopic handler.
Before Operation Safety Reminders
 Check brakes, steering, and hydraulic system prior
to starting operation. Operate all controls to ensure
proper operation. Observe all gauges and indica-
tors for proper operation. If any malfunctions are
found, correct the cause prior to using the machine.
 ALWAYS wear appropriate personal protective
equipment for the job and working conditions.
Hard hats, goggles, protective shoes, gloves,
reflector-type vests, respirators and ear protection
are examples of types of equipment that may be
required. DO NOT wear loose-fitting clothing,
long hair, jewelry or loose personal items while
operating or servicing the machine.
 ALWAYS check the job site for terrain hazards,
obstructions and people. Remove all objects that
do not belong in or on the machine and its equip-
ment.
 Walk around the machine and warn all personnel
who may be servicing the machine or who are in
the machine’s path prior to starting. DO NOT start
until all personnel are clearly away from the
machine.
 The operator must immediately advise his supervi-
sor if the telescopic handler is not in good working
condition.
 The operator must carry out daily maintenance
(see chapter: 6 - MAINTENANCE: A - DAILY
OR EVERY 10 HOURS SERVICE) if this is
among his responsibilities.
Operation Safety Reminders
 Any or all of the following elements may affect the
stability of the machine: terrain, engine speed, type
of load being carried and placed, improper tire
inflation, weight of the attachment tool, and abrupt
movement of any control lever. IF YOU ARE NOT
CAREFUL WHILE OPERATING THIS
MACHINE, ANY OF THE ABOVE FACTORS
COULD CAUSE THE MACHINE TO TIP AND
THROW YOU OUT OF THE OPERATOR’S
STATION, WHICH MAY CAUSE SERIOUS
BODILY INJURY OR DEATH!
 ALWAYS wear the seat belt provided to prevent
being thrown from the machine. If you are in an
overturn:
- DO NOT jump!
- Hold on tight and stay with the machine!
- Lean away from the fall!
 ALWAYS use the recommended hand holds and
steps with at least three points of support when get-
WARNING
There are a number of possible situations in
which operating the telescopic handler is not
allowed. Such abnormal uses are strictly for-
bidden. For example:
- Abnormal behavior resulting from careless-
ness.
- Behavior resulting from “doing it the easy
way” when performing a task.
- Operation by such persons as: teenagers,
handicapped persons, trainees tempted to
drive a telescopic handler, and operators
tempted to operate in a manner to win a bet, in
competition or for their own personal experi-
ence.
The person in charge of the equipment must
take these possibilities into account when
assessing whether or not a person will make a
suitable operator.
Courtesy of CraneMarket.com
To Next Page
Loading...
Need help?
General
