913225/CP0807 20 PRINTED IN U.S.A.
Modifications, Nameplates, Markings and
Capacities
 Modifications and additions that affect capacity or
safe operation must never be performed without
the manufacturer’s prior written approval. Where
such authorization is granted, any applicable mark-
ings are to be changed accordingly.
 All attachment tools MUST be marked to identify
the attachment tool and the total capacity with the
attachment tool at maximum elevation with the
load laterally centered.
 Be sure all nameplates, warnings and instruction
markings are in place and legible. Local govern-
ment regulations may require specific equipment,
which is the responsibility of the owner to provide.
 Replace any warning decals that are no longer leg-
ible.
Safety Guards and Warning Devices
 This machine is fitted with a Roll-Over Protective
Structure (ROPS) and Falling Object Protective
Structure (FOPS) in accordance with industry stan-
dards. It is intended to offer protection to the oper-
ator from falling objects and in case of an overturn,
but it cannot protect against every possible hazard.
Therefore, it should not be considered a substitute
for good judgment and safe practices in operating
the machine. If the ROPS / FOPS structure is dam-
aged, it must be replaced to restore the protection
it provides.
Courtesy of CraneMarket.com
To Next Page
Loading...
Need help?
General
