Bit# Options: Function:
N1
0 Nontaxable on cut-price after subtotal. The settings in N2 and N3 are
ignored.
1 Taxable on cut-price after subtotal.
N2
0 Do not specify TAX4.
1 Specify TAX4.
N3
0 Specify no TAX.
1 Specify TAX1.
2 Specify TAX2.
3 Specify TAX1 and TAX2.
4 Specify TAX3.
5 Specify TAX1 and TAX3.
6 Specify TAX2 and TAX3.
7Specify TAX1, TAX2 and TAX3.
To move to -% 2, just press
PAGE UP
. To return to PROGRAM 1 MENU, press
ESC
.
4.9 Setting CLERK NAME
Setting Clerk Name and ID
Ten clerk names and ID’s can be programmed. Names up to 8 characters, and ID is up to
4-digit. The clerk ID will allow operators to operate the cash register in the “R” mode. By
flag setting, an operator cannot operate the cash register without entering a correct pass-
word and
ID
key. The clerk name can be programmed up to 8 letters.
To correct wrong spelling, press
OVER WRITE
key, and move highlighted space by
key,
and then after the right letter is input, press
OVER WRITE
key again. If the displayed name
is correct, press
ENTER
.
To return to PROGRAM 1 MENU, press
ESC
.
:
How to make passwords non-displayed.
The number can be displayed as a non-displayed number by pressing
RA
key previously.
The function is useful for entry of ID# or passwords.
Example
:
Control lock key position: R
Press
RA
and 1234 (=ID#): Display stays “0.”
NOTE
4. P1 programming
24
1
2
3
4
5
6
7
8
9
10
11
12
To Next Page
Loading...
