Geller TL-550 - Special Functions; Training Mode

62
1
2
3
4
5
6
7
8
9
10
11
12
10. Special Functions
This chapter describes various special functions of this cash register. The settings for these
functions are described in section “5.1 Setting SYSTEM FLAG.”
10.1 Training Mode
To train an operator, this cash register has the training mode. First, enter the training
mode and then let the operator do simulated operations. When the training is finished, be
sure to return to the normal operation mode. (Please refer to Training Password in 5.2)
To enter the training mode:
Control lock key position: X
Enter 3 (TRAINING MODE), and press
ENTER
.
/If the password is not programmed yet, the displayed message is “NOT TRAIN-
ING PASSWORD!.” Please program the password first.
/If the password is programmed, the displayed message is “PASSWORD?”
Then, enter your password.
/If the password is wrong, the displayed message is “PASSWORD ERROR.”
Press CLR key and enter the correct password.
/If the password is correct, the X MODE REPORT screen returns with the symbol
of ‘T’ in the bottom, left-hand corner.
Turn the control lock key to R, and you will find you are in the training mode. Then start
the training.
To return the normal operation mode, turn the control lock key to X again, and enter 3 and
press
ENTER
. When you are asked “PASSWORD?” enter the correct password and press
ENTER
. Then the X MODE REPORT screen returns without the symbol of “T.” It means
you are already in the normal operation mode.