GEM 1435 ePos - Page 25

12.4 Electrical connection with M12
Note: Ordering option Option code 1, 3, 5, 7
Position of the connectors
X1
X3
X2
Connection X1
1
4
3
2
5
Pin Signal name
1 Uv, 24 V DC supply voltage
2 Uo, error message output, 24 V DC
3 Uv, GND supply voltage
4 Uo, alarm output 1, 24 V DC
5 Uo, alarm output 2, 24 V DC
Connection X2
1
4
3
2
5
Pin Signal name
1 Iw+, set value input 0/4–20 mA *
2 Iw-, set value input 0/4–20 mA *
3 X+, actual value output 0 - 10 V / 4-20 mA
4 X-, actual value output 0 - 10 V / 4-20 mA
5 n.c.
* For set value input Uw = 0 - 10 V on-site rewiring is required
Connection X3 (for travel sensor connection)
1
5
4
3
2
Pin Signal name
1 UP+, actual value supply 10 V DC
2 UPsig, actual value input 0–10 V DC
3 UP-, actual value supply GND
4 n.c.
5 n.c.
GEMÜ 1435 ePoswww.gemu-group.com 25 / 71
12 Electrical connection