GEM 1435 ePos - Page 42

www.gemu-group.com42 / 71GEMÜ 1435 ePos
17 System mode ADVANCED
Menu levels Submenu Display Function Value range Default setting
Init All Submenu for carrying out the initialization
GoClose Scanning the closed pos-
ition
GoOpen Scanning the open posi-
tion
AdjTime Scanning the travel times
FindCoefficent Optimization of control
characteristics
Init Pilot Setting the minimum
travel times for internal
pilot valves
CalPointQty Quantity of calibration
points when initializing
1 ... 19 2
D.Refresh Time for display refresh 0.1 ... 1.0 s 0.5 s
Systemmode Type of operator inter-
face
Classic / Advanced Classic
DLight Setting the display light-
ing
OnKey / On OnKey
DLightTime Time for switching off
display lighting with the
OnKey setting
1 ... 60 min 5 min
HelpLanguage Text language D / GB D
HelpText Display the help text ON / OFF ON
3 SetFunction PosCtrl Submenu for setting positioner parameters
Prop Gain P amplification of the po-
sitioner
0.1 ... 100.0 X.X
Deriv Time Decay time of the D com-
ponent of the positioner
0.0 ... 10.0 s 0.1 s
MinPos Closing limit = lower pos-
ition of control range
0 ... 100 % 0.0 %
MaxPos Stroke limitation = upper
position of control range
0 ... 100 % 100 %
CloseTight Close tight function no, Min/Max, Max,
Min
no
DeadBand Permissible system devi-
ation
0 ... 100 %, auto 1.0%, K-no.
2442: 2.0%, K-
no. 2443: 5.0%
AlarmOutput Submenu for setting the alarm outputs
Alarm Fn Defines the function of
the alarm output
OFF, min/max, min/
min, max/man
OFF
Level Alarm 1 Switch point of alarm 1 0.0 ... 100 % 10.0 %
Level Alarm 2 Switch point of alarm 2 0.0 ... 100 % 90.0%
ErrorOutput Submenu for setting the error output
Error Functn Defines the function of
the error output (Error)
Error. Error+Inactive,
Range, Error+Range,
Error+Range+Inact-
ive
Error+Range
Error Time Valve travel time monit-
oring
(error output)
AUTO,
0.0 to 100.0 s
AUTO