INSTALLER MANUAL - PAGE 15
• The system is ready to receive the device codes.
• Depending on which device is to be stored in memory, either press
,
• If learning is successful, a short Beep will sound and the LED will go out for 1 sec .
•.
• Turn ignition key “OFF”.
•A
•).
one of the buttons on the
remote control, touch the key to its receptacle make the magnetic
contact transmit (bring contact and magnet together and then move apart) press the button on the
opening detector or make the infrared sensor transmit (see sensor instructions).
Repeat this same procedure to learn other devices
Bop will sound, the turn indicators will flash once and the status LED will go out to confirm the
end of the procedure.
Close the bonnet or remove the GREEN wire from ground (bonnet switch
have the transponder transmit,
,
All devices previously programmed in the system memory can be deleted. To clear the memory
proceed as follows:
With the system disarmed, open the vehicle bonnet and keep it opened or ground the GREEN
wire.
•
11.0 - DELETING PROGRAMMED DEVICES
To carry out the operation successfully, make sure the required connections
(bonnet switch and ignition) are complete.
If there is no bonnet switch, ground the GREEN wire (20-pin connector, pos. 15
).
!
• Cycle the ignition key 4 times: “ON-OFF” - “ON-OFF” - “ON-OFF” - “ON”.
•At the 4th cycle leave ignition “ON”.
• To confirm it has entered in clear mode, 2 acoustic signals will sound (a Beep and a Bop), the turn
indicators will flash once and the go out.
• Close the bonnet or remove the GREEN wire from ground (bonnet switch).
• To clear the memory, leave the bonnet closed for at least 8 sec.
status LED will
The following “ON-OFF” cycles must be carried out within 4 seconds otherwise the
procedure is invalidated.
If the bonnet is opened before 8 sec., the devices will not be deleted.
•.
• Turn ignition key “OFF”.
•.
The LED will switch OFF when the devices have been deleted
Along low-pitched sound confirms the end of the clearing procedure
!
!
To Next Page
Loading...
