Gemini 932IT - Pinout Tables; 20-Pin Connector Pinout; 8-Pin Connector Pinout

4.0 - PINOUT TABLES
-1-
-2-
-3-
-4-
-5-
-6-
-7-
-8-
-9-
-10-
-11-
-12-
-13-
-14-
-15-
-16-
-17-
-18-
-19-
-20-
-----
YELLOW-BLUE
GREEN-BLUE
-----
GREEN-BROWN
GREEN
BROWN
BLACK
RED
BLACK marked “G”
LIGHT BLUE-GREY
LIGHT BLUE
PINK
GREEN-BLACK
GREEN
BLUE
WHITE-BLACK
YELLOW-BLACK
-----
WHITE-ORANGE
WIRE FUNCTIONPOSITION
WIRE COLOR
+
4.1 - 20-PIN CONNECTOR
INSTALLER MANUAL
-----
-----
Door switches - Positive/negative input
Touch key receptacle input
Touch key receptacle ground
LED negative output
LED positive output
Ignition
CAN BUS (CAN-H) signal
CAN BUS (CAN-L) signal
Positive output - System armed (+A)
External sensors negative input
Bonnet switch negative input
Hazard lights or negative outut during alarm (siren,
pager, tracker)
Lock command (1,5 sec.* negative pulse when pressing
remote control button “1” or “3”)
Unlock command (1 sec. negative pulse when pressing
remote control button “2”)
-----
Input for learning and arming/disarming via turn
indicator flashes
System arming confirmation signal
System disarming confirmation signal
PAGE 08 - INSTALLER MANUAL
Ground
Siren output
Positive supply
Turn indicators positive output
Engine immobilizer
Siren output
Engine immobilizer
Turn indicators positive output
-1-
-2-
-3-
-4-
-5-
-6-
-7-
-8-
BLACK marked “M”
-----
BLACK marked “R”
ORANGE
BLACK marked “H”
-----
BLACK marked “H”
ORANGE
WIRE FUNCTIONPOSITION
WIRE COLOR
4.2 - 8-PIN CONNECTOR
For more complete information regarding connections, refer to the
(
supported vehicle
models private area).
installation instructions at www.gemini-alarm.com
* If this function is enabled, the lock/unlock pulse will be 1,5 sec.0,5 sec. instead of