USER GUIDE - PAGE 05
2.9 - ALARM MEMORY
The LED memory allows to identify the last alarm event signaled by 5 siren chirps and 5 turn indicator
flashes when the system is disarmed.
Turn ignition key “ON”. The status LED will flash according to the last alarm detected prior to disarming
(see table below).
The flash sequence is repeated 3 times; to interrupt simply turn ignition key “OFF”.
The table below lists the various alarm causes and relative number of LED flashes.
LED FLASHES ALARM CAUSES
ALARM
CYCLES
10
10
1
1
0
10
0
10
10
10
Ignition attempt (+15/54)
Boot opening
Wireless magnetic contacts or
opening detectors
Wireless (PIR) sensors
Door opening
Bonnet opening
Volumetric or external sensor
Wire tampering
LED ON (1 second)LED OFF (2 seconds)
To Next Page
Loading...
Need help?
General
