3.3 - RFID TRANSPONDER - 908
REPLACING THE BATTERY
to disable the engine immobilizer.
To activate the transponder simply presss the button and keep it pressed for at least 4 sec. The LED
turns ON steady when the transponder is activated. Release the button. The LED will flash everytime
data is transmitted.
If no movement is detected within 10 min. the transponder automatically goes into standby mode to
save battery life; to wake it up for another 10 min., move it or press the button. Press the button again to
send a radio signal to the alarm system.
To switch OFF the transponder, press and hold the button. The LED will be ON steady, it will flash twice
when the transponder has been switched OFF.
:
+
Separate the shells and
carefully remove the
circuit.
Slide out the dead
battery and insert the
new one. Pay attention
not to invert polarity.
Reassemble the shells, turn
ON the tansponder and
make sure it works.
USER GUIDE - PAGE 07
.
Use only CR2032 batteries.
Different type batteries can seriously damage the transponder
Discard used batteries properly in special dedicated containers.
ATTENTION
!
To Next Page
Loading...
Need help?
General
