Genesis GV60 - Page 319

5-122
Convenience features
Information
• The cabin air filter needs to be replaced
per every 15,000 km (10,000 miles) to
maximize efficiency of the clean air
system.
•
If the vehicle is driven in an inner city
area with high air pollution or severe
conditions such as dusty or rough roads
or the indoor fine dust concentration
is not presented as Good on the screen
due to prolonged heavy fine dust, have
the cabin air filter inspected. If the
cabin air filter is contaminated, fine
dust concentration may be displayed as
Poor or Very Poor on the screen.
•
We recommend using genuine cabin
air filter to maintain the optimal
performance ofthe clean air system.
•
Use genuine Genesis cabin air filter to
maintain the optimal performance of
the clean air system.
When a cabin air filter that has low
dust collection efficiency or poor dust
removal performance is used, or if
you use a cabin air filter that does
not meet the specification, fine dust
concentration may be displayed as Poor
or Very Poor on the screen.
•
Presented dust concentration is
measured inside the vehicle in realtime
so the measured value is differed
from the dust concentration in the
atmosphere.
•
The presented figure might be varied
by the mensuration or measurement
locations so please use it as a reference.
•
The fine dust concentration value is
the result of measuring the number of
dust and converting it to the fine dust
concentration using an optical method.
•
The fine dust concentration is displayed
from 0 to 199.
•
The measured fine dust concentration
value may be different from the
measurement standards of other
instruments or products.
- If the fine dust concentration is high,
the displayed fine dust concentration
may differ from the actual
concentration level.
•
The time of concentration level
measurement may be delayed since the
spread of fine dust is slow.
•
Movement around the fine dust sensor
interferes with normal operation of
the sensor. The displayed fine dust
concentration may differ from the
actual concentration level.
•
In the following environments, the fine
dust concentration can be displayed
differently from the actual level.
- Hairy products, bugs or pets are
present
- A vacuum cleaner is used
- Humidity is high
- A door or window is opened letting
the outside air in
- Outside air from a construction site,
factory or ventilator enters
- A product that generates vapors or
fine particles (humidifiers, sprays,
etc.) is used
- Even if the dust is generated by
activities such as dusting or cleaning,
the fine dust sensor may not respond
if the dust is large (PM10 or higher).
It will be removed by the cabin air
filter.