Genesis GV60 - Page 551

7-124
Driver assistance system

Highway Lane Change Assist function
will be in the standby state when one of
the ready state condition is not satisfied,
or when entering or driving on one of the
following roads:
•
Road within a certain distance from
the tollgate on the main road of the
highway (or motorway)
•
The road ahead ends without an
interchange or junction
• Road with sharp curves
•
Road with narrow lanes
•
Road that is under construction

The function will be canceled when:
•
The turn signal lever is moved to the
A position while the Highway Lane
Change Assist function is operating
and placed in the center (1) before
stepping on the lane line.
•
The turn signal lever is turned on in
the opposite direction of lane change
•
The steering wheel is steered sharply

• 
function will cancel if one of the
following occurs:
- 
off
- Lane Following Assist or Smart
Cruise Control is turned off or

- 

- 
position
- 
turned on
- 
Assist or Blind-Spot Collision-


- 


Assist and Blind Spot Collision-

- 
- The target lane to make a lane
change disappears
- The target lane to make a lane
change is not detected
- 
lamps