7-200
Driver assistance system
OJWEV071285LOJWEV071285L
(1) Press the Parking/View ( )
button when the vehicle is stopped
by depressing the brake pedal.
When the brake pedal is released,
Remote Smart Parking Assist will
automatically control the steering
wheel, vehicle speed and gearshift.
(2)
While Smart Exit function is
operating, if you do not hold down
the Parking/View button, the vehicle
will stop and function control
will pause. The function will start
operating again when the Parking/
View button is pressed and held
again.
(3)
When the vehicle reaches the target
exit location, a message will appear
on the infotainment system screen to
inform you that exit is complete.
•
Smart Exit function will not operate
if the door is open or the seat belt is
not fastened.
•
Vehicle speed can be adjusted
by depressing the brake pedal
while Smart Exit function is
operating. However, the vehicle
does not accelerate even when the
accelerator pedal is depressed.
•
If exit is completed while
depressing the brake pedal, Smart
Exit function will complete with the
gear in D (Drive).
•
If exit is completed while depressing
the accelerator pedal, you must
take your foot off the accelerator
pedal once for the accelerator pedal
to operate.
•
If there is no vehicle operation such
as depressing the brake pedal or
accelerator pedal within 4 seconds
after exit is complete, the vehicle
will automatically shift to P (Park)
and engage EPB (Electronic Parking
Brake).
•
After Exit function is complete,
always check the surroundings
before driving.
Smart Exit operation status
Operation
status
Turn signal
Under
control
The turn signal of the exit
direction blinks until the exit
is complete or Smart Exit is
canceled.
à Operation status by the turn signal
may not be applicable based on the
regulation of your country.
To Next Page
Loading...
