Safety Directions Zoom90 | 13
1.6.8 Laser Plummet
General The laser plummet built into the product produces a visible red laser beam which emerges from the bottom
of the product.
The laser product described in this section is classified as laser class 2 in accordance with:
• IEC 60825-1 (2014-05): “Safety of laser products”
These products are safe for momentary exposures but can be hazardous for deliberate staring into the
beam. The beam may cause dazzle, flash-blindness and after-images, particularly under low ambient light
conditions.
CAUTION
From a safety perspective, class 2 laser products are not inherently safe for the eyes.
Precautions:
1) Avoid staring into the beam or viewing it through optical instruments.
2) Avoid pointing the beam at other people or at animals.
Labelling
1.7 Electromagnetic Compatibility EMC
Description The term Electromagnetic Compatibility is taken to mean the capability of the product to function smoothly
in an environment where electromagnetic radiation and electrostatic discharges are present, and without
causing electromagnetic disturbances to other equipment.
WARNING
Electromagnetic radiation can cause disturbances in other equipment.
Although the product meets the strict regulations and standards which are in force in this respect, GeoMax
cannot completely exclude the possibility that other equipment may be disturbed.
CAUTION
There is a risk that disturbances may be caused in other equipment if the product is used with accessories
from other manufacturers, for example field computers, personal computers or other electronic equip-
ment, non-standard cables or external batteries.
Precautions:
Use only the equipment and accessories recommended by GeoMax. When combined with the product, they
meet the strict requirements stipulated by the guidelines and standards. When using computers or other
electronic equipment, pay attention to the information about electromagnetic compatibility provided by
the manufacturer.
Description Value
Wavelength 640 nm
Maximum average radiant power 0.95 mW
Pulse duration 10 ms - cw
Pulse repetition frequency (PRF) 1 kHz
Beam divergance <1.5 mrad
a) Laser beam
b) Exit for laser beam
009831_001
a
b
To Next Page
Loading...
