GeoMax Zoom90 - Remote Control Setup with RadioHandle; Connecting to a Personal Computer

Zoom90 | 26Operation
4.4 Setting up for Remote Control (with the RadioHandle)
Setup for remote control
with RadioHandle
4.5 Connecting to a Personal Computer

Microsoft ActiveSync (for PCs with Windows XP operating system) or Windows Mobile Device Center (for
PCs with Windows Vista or Windows 7/Windows 8/Windows 10 operating system) is the synchronisation
software for Windows mobile-based pocket PCs. Microsoft ActiveSync or Windows Mobile Device Center
enables a PC and a Windows mobile-based pocket PC to communicate.
Install GeoMax Zoom90
USB drivers
Connect USB cable to
computer for the first
time step-by-step
a) Prism
b) Prism pole
c) Data logger with Bluetooth
d) Holder
e) RadioHandle
f) Instrument
g) Tripod
a
b
c
009856_001
a
b
d
f
g
e
Step Description
1. Start the PC.
2. Download the GeoMax Zoom90 USB driver from the GeoMax Download page.
3. Run the SetupZoom90_USB_XX.exe to install the drivers necessary for GeoMax Zoom90.
Depending on the version (32bit or 64bit) of the operating system on your PC, you have to
select between the three setup files following:
• _USB_32bit.exe
• _USB_64bit.exe
• _USB_64bit_itanium.exe
4. The InstallShield Wizard window appears.

Ensure that all GeoMax devices are disconnected from your PC before you continue!
5. Next>.
6. The Ready to Install the Program window appears.
7. Install. The drivers will be installed on your PC.

For PCs with Windows Vista or Windows 7/Windows 8/Windows 10 operating
system: If not already installed, Windows Mobile Device Center will be installed addi-
tionally.
8. The InstallShield Wizard Completed window appears.
9. Check I have read the instructions and click Finish to exit the wizard.
Step Description
1. Start the computer.
2. Plug the USB cable into TPS instrument.
3. Turn on the TPS instrument.
3
2
4
011050_001