GeoMax Zoom90 - Page 35

Settings Zoom90 | 35
Configuration Bluetooth
Configuration RS232
DEFAULT
To set all values to factory default.
Field Description
Pin The Pin code needed to communicate to the instrument. The default
value is 0000. Before the new Pin will be active, a reboot of the system
would be required.
DEFAULT
To set all values to factory default.
Field Description
Baudrate Speed of data transfer from receiver to device in bits per second.
1200, 2400, 4800, 9600, 14400, 19200, 38400, 57600, 115200
Parity Even Even parity.
Odd Odd parity.
None No parity.
Data bits Number of bits in a block of digital data.
7 Data transfer is realised with 7 databits.
8 Data transfer is realised with 8 databits.
Stop bits 1 Number of bits at the end of a block of digital data.
Flow control None
On