GeoVision GV-VS14 User Manual

Auxiliary Device Connectors
9
9.1.2 Relay Output
The relay outputs on the terminal block only drives a maximum load of 5 volts. Working in
conjunction with the GV-Relay V2 module, it is capable of driving heavier loads. Refer to
the figure and table below to connect the GV-Relay V2 module to the GV-Video Server.
Note: The GV-Relay module is an optional product.
Output Devices 1-4
Figure 9-2
GV-Relay V2 I/O Terminal Block
DO 1 Pin 1
DO 2 Pin 3
DO 3 Pin 5
DO 4 Pin 7
+ 5V Pin 9
Note that you don’t need to use the DC 5V connector on the GV-Relay V2 module for
power supply, since the power is supplied from the GV-Video Server.
137

GeoVision GV-VS14 Specifications

General

PAL resolutions	704 x 576, 704 x 576, 352 x 288, 352 x 288, 176 x 144 pixels
NTSC resolutions	704 x 480, 704 x 480, 352 x 240, 352 x 240, 176 x 112 pixels
Channels quantity	4 channels
Maximum frame rate	30 fps
Maximum video resolution	704 x 576 pixels
Video compression formats	H.264, M-JPEG
PTZ control	Yes
Compatible operating systems	Windows XP\\r Windows Vista\\r Windows 7\\r Windows 8\\r Windows Server 2008\\r Windows Server 2012
Product color	Black, White
Supported network protocols	HTTP, HTTPS, TCP, UDP, SMTP, FTP, DHCP, NTP, UPnP, DynDNS, 3GPP/ISMA, Multicast, RTSP, QoS (DSCP), SNMP
Copper ethernet cabling technology	100BASE-T, 10BASE-T
BNC input ports	4
I/O terminal ports	-
USB 2.0 ports quantity	2
Ethernet LAN (RJ-45) ports	1
Minimum system requirements	Internet Explorer 7+
Power requirements	12V, 1.35A
Operating temperature (T-T)	-20 - 55 °C
Operating relative humidity (H-H)	0 - 85 %

Weight and Dimensions

Weight	730 g
Dimensions (WxDxH)	145 x 174 x 40 mm