13
4 If you are loading a
new foil cartridge,
remove and discard
the foam core locks
from the cartridge.
5 Hold the cartridge
vertically with the
label facing to the left.
Orient the cartridge
so that the glossy side
of the foil faces
toward the print
head.
6 Insert the cartridge toward the rear of the cover until the label end
touches the support bracket.
7 Rotate the cartridge
to the right until it
covers the cartridge
pin plate and the left
side of the cartridge is
behind the curve of
the support bracket.
8 Slightly rotate the
three cartridge pins
under the cartridge
pin plate so that they
release and secure the
foil cartridge in the
head support.
9 Press FOIL SLEW until the foil is tensioned across the printhead. You
may hear the foil drive sprockets snap into place as you do this.
10 Close the cover.
Note: You can check the
amount of foil remaining by
looking through the
viewing hole on the end of
the roll that would be on
the bottom when the
cartridge is mounted in the
EDGE 2.
Glossy side
Cartridge pin
late
Curve of
support
bracket
Cartridge pins
Viewing hole
To Next Page
Loading...
Need help?
General
