3
CAUTION: A caution statement contains information which, if not
observed, could result in damage to the equipment.
WARNING: A warning statement contains information which, if not
observed, could result in personal injury.
This typestyle portrays messages that appear on either the EDGE 2’s LCD
message display or your computer’s monitor.
Safety
WARNING: Unplug the power cord before performing any
maintenance. Voltage is present inside the system even after the power
switch is turned off. All voltage is removed only when the power cord
is unplugged.
CAUTION: Static electricity may damage electronic components.
Ground yourself by touching any bare metal inside the EDGE chassis
prior to handling electronic components.
Unpacking or repacking the EDGE 2
The EDGE 2 is shipped from the factory in reusable packaging materials.
Save these packaging materials for future use in case you need to ship
the EDGE 2. Provided separately with the EDGE 2 is the bulletin
Unpacking and Repacking to Prevent Damage. Please refer to this bulletin
for complete instructions on either unpacking your EDGE 2 or repacking
it for shipment.
CAUTION: Failure to repackage the printer with the specified
packaging materials may result in damage to the unit during shipping.
Always repack the printer as described in the bulletin Unpacking and
Repacking to Prevent Damage. Gerber is not liable for shipping
damage due to improperly packed units. If you do not have the proper
packaging materials, call the Gerber Field Service Department at 800-
828-5406.
Contents of the shipping boxes
The GERBER EDGE 2 is shipped in two boxes: an EDGE 2 box and a
system components box.
The EDGE 2 box contains cushioning material and an inner box. The
GERBER EDGE 2 thermal printer is packaged in the inner box along with
the following:
An EDGE 2 power cable
To Next Page
Loading...
Need help?
General
