26
CHAPTER 5
Troubleshooting
allow it to normalize to the environment and be sure to use the tension
arm roller.
Stretched sprocket holes in the vinyl. Use materials that are Gerber-
approved for the EDGE 2. Unroll the vinyl before printing and be sure
to use the tension arm roller. Check that the movable rear sprocket
moves freely. If the problem persists, please call your distributor or
the Gerber Field Service Department.
Lifting printed images from the material or lifting material from the
liner. A job printed on vinyl, film, or sheeting can be sensitive to
transfer tape pressure. Wait at least 15 minutes before applying
transfer tape to the printed vinyl, film, or sheeting. Use only Gerber
Standard Tack Application Tape.
Tip: Do not stack printed materials print-side to print-side. Stack the
printed side contacting the liner side of another piece of material or use a
paper interleaf between the layers.
Startup problem
If your EDGE 2 is connected to the PC through an Iomega® ZipPLUS™
drive, Windows might fail to start if the EDGE 2 is already turned on
while the computer is starting up. If you have this arrangement, turn off
the EDGE 2 when starting the computer. Turn it on once Windows is up
and running.
To Next Page
Loading...
Need help?
General
