Gerber EDGE 2 User Manual

31
Index
A
Aborting a job........................................... 18
Add vinyl printer ........................................ 7
Adjusting darkness ................................... 15
B
Bail arm.................................................... 10
C
Cartridge pins ........................................... 13
Check foil message................................... 18
Checksum setting...................................... 21
Cleaning
bail arms............................................... 27
dancer bar............................................. 27
foil .......................................................... 9
material................................................... 8
platen.................................................... 28
printhead............................................... 27
sprockets............................................... 27
squeegees.............................................. 27
Color correction table, choosing............... 15
Confirm reset message ............................. 18
Connecting to a PC..................................... 5
Control panel............................................ 16
Customer support ....................................... 2
Cutting after printing................................ 19
D
Dancer bar
cleaning ................................................ 27
location................................................. 12
Darkness setting, adjusting....................... 15
Data error message ................................... 21
DPI, setting............................................... 15
E
ECP printer port, required...........................5
Edge Ready material................................... 8
EDGE, matching print from...................... 15
E-mail to Gerber.........................................2
Error messages.......................................... 23
Eyepiece
correct registration with target.............. 20
inserting into tool carriage.................... 19
F
Factory settings, resetting ......................... 21
Foil
check remaining.................................... 13
cleaning................................................... 9
importance of using specified............... 15
loading .................................................. 12
running out of .......................................18
slew key................................................ 16
storing..................................................... 9
substituting............................................ 15
tensioning.............................................. 13
unloading cartridge ............................... 12
Fuse
location ................................................. 28
replacement........................................... 29
G
GAPlot32
switching foil and material....................15
used to set up output .............................14
Getting help ................................................ 2
GSP Setup, installing EDGE 2 ...................7
H
Heat and humidity.......................................8
Help ............................................................ 2

Gerber EDGE 2 Specifications

General

Brand	Gerber
Model	EDGE 2
Category	Printer
Language	English