24
CHAPTER 5
Troubleshooting
Message Required Action
PAUSED
This message appears when ONLINE is
pressed while the EDGE 2 is printing.
Press ONLINE again to resume printing.
Press RESET to return to OFFLINE status.
CHECK FOIL
Make sure foil is correctly loaded and
press ONLINE.
CHECK VINYL
Make sure vinyl is correctly loaded and
press ONLINE.
DATA ERROR
n
(Where
n
is a number)
1
Check the cabling between the
computer and the EDGE 2.
2
Make sure the EDGE 2 checksum
setting is the same as the Gerber
software checksum setting (refer to
“Changing the checksum” on page 21).
3
Terminate all EDGE 2 jobs in Gerber
Spooler.
4
Press RESET. The EDGE 2 is offline.
5
Press ONLINE. The EDGE 2 is online.
6
Retry the job.
If the message continues, contact your
distributor or the Gerber Field Service
Department and tell them the data error
number.
THERMISTOR ERROR
Wait for printhead to cool down. When
printhead is sufficiently cool, the
Paused
message is displayed.
WARMING UP
Wait for machine to warm up and printing
to start.
WARMUP ERROR
If warmup takes longer than 5 minutes,
this non-recoverable error message
appears. Press the Reset key and call the
Gerber Field Service Department.
Z AXIS HOME ERROR
Call the Gerber Field Service Department.
HOST INIT ERROR
Call the Gerber Field Service Department.
To Next Page
Loading...
Need help?
General
