Getting Started with the GERBER EDGE 23
11. Press F8 on the GRAPHIX ADVANTAGE keyboard to cut the
job.
12. Press the plotter RUN SINGLE key when the plotter indicator light
blinks.
13. When the job is done, slew the vinyl out of the machine and weed
the job.
Additional Sample Jobs
There are additional sample jobs on your GRAPHIX ADVANTAGE
system. They are .PLT files in the C:\JOBS directory.
Try printing some of them using the preceding sequence. You will have
to enter a different file name at step 5 in "To Set Up the Job." Also note
that the vinyl and foil colors may be different from the two sample jobs
you just printed. Finally, some jobs may have more or less than two
printed colors. For assistance refer to the "Procedures for Using the
GERBER EDGE" section.
To Next Page
Loading...
