Troubleshooting 55
Fuse Replacement
Two spare 10-Amp fuses are packed in the accessory tray of the shipping
package. If you need to replace a fuse, locate the fuse carrier immediately
above the power switch on the left side of the machine. It is labeled
"10A 250V SB" and has a notch at the bottom of the plate.
To replace a fuse
1. Remove the power cord from the GERBER EDGE.
2. Insert a small flat screwdriver into the notch from below and pull out
the fuse carrier plate.
Removing the fuse carrier and fuses.
3. Remove the fuse(s) from the fuse carrier. Insert new fuse(s).
4. Insert the fuse carrier into the GERBER EDGE with the notch
down and snap into place.
5. Reconnect the power cord.
Assistance
If you require assistance, please contact your Gerber distributor or
contact the Gerber Field Service Department at:
800-828-5406 (USA and Canada)
203-643-1515 (International)
203-290-5568 (fax)
To Next Page
Loading...
