Gerber Edge - Print Material Guidelines

Procedures for using the GERBER EDGE 35
Maintaining Print Quality
Quality printing and cutting depend on several factors:
!
The material must be clean.
!
The foil must be clean.
!
The printhead, squeegees, platen, and sprockets must be clean.
!
The printed image must be exactly registered with the plotter knife
and you must cut on the plotter you selected prior to printing.
Cleaning
The material, foil, printhead, squeegees, platen, and sprockets must be
clean.
THE MATERIAL
Gerber has created a new material designation called "Edge Ready."
Edge Ready materials are processed, prepared, and qualified by the
material manufacturer for optimum image quality when printing with
the GERBER EDGE. Edge Ready materials are the only materials
recommended for use with the GERBER EDGE. Edge Ready material
is identified by an Edge Ready sticker inside the roll and on the outside
of the box.
To remove any surface dust or dirt, gently wipe the material with a clean,
dry, lint-free cloth before printing and between colors.
When you are not using the material, store it in the plastic wrap it
originally came in. Following this advice should keep print quality high
and material loss low.