Gerber Edge - Fuse Replacement Procedure; Technical Assistance Contact

50 GERBER EDGE Owner's Guide
4. Release the Reset key. The GERBER EDGE is reset to factory
parameters.
SETUP MENU
When you press the Setup (SU*) key from the Offline mode, the
GERBER EDGE enters the Setup menu. The Setup menu allows you
to change the print test pattern or the GERBER EDGE checksum. To
change the print test pattern, repeatedly press the Setup key until the
keypad display reads "TEST PATTERN" followed by the test pattern
number. Press either vinyl slew key to step through the test pattern
choices, then press the Reset (RS) key to return to the Offline mode.
There are special reasons for using the Setup key regarding the checksum
setting:
!
The checksum setting of the GERBER EDGE must be the same as
the checksum setting of the GRAPHIX ADVANTAGE software
release.
!
The checksum setting of the GERBER EDGE must be the same as
the checksum setting embedded in the spool file being printed.
Matching the Checksum of the GERBER EDGE to the
GRAPHIX ADVANTAGE
If the GRAPHIX
ADVANTAGE Release installed
on your computer is:
Then the GERBER EDGE
checksum must be set to:
4.3 or higher OFF (This is the GERBER
EDGE setting. You do not have
to change the setting.)
4.1 ON (You must change the
setting.)
If the GERBER EDGE checksum is not set correctly, you will not be
able to print on the GERBER EDGE and you will get a "Data Error"
message on the keypad display every time you send a job.