EasyManua.ls Logo

Getac K120G2 - Using Recovery Partition

Getac K120G2
126 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
88
The computer does not resume from Sleep or Hibernation mode.
The computer automatically enters Sleep or Hibernation mode when the
battery pack is empty. Do any one of the following:
Connect the AC adapter to the computer.
Replace the empty battery pack with a fully charged one.
Wake-on-LAN (WoL) doesn’t seem to work.
If your computer is connected to an older generation of keyboard, office,
or vehicle dock, waking up from Microsoft Modern Standby mode is not
supported.
Software Problems
An application program does not work correctly.
Make sure that the software is correctly installed.
If an error message appears on the screen, consult the software
program’s documentation for further information.
If you are sure the operation has stopped, reset the computer.
Sound Problems
No sound is produced.
Make sure that the volume control is not set too low. Increase the
volume.
Make sure that the sound is not muted.
Make sure that the computer is not in Sleep mode.
If using an external speaker, make sure that the speaker is properly
connected.
Distorted sound is produced.
Make sure that the volume control is not set too high or too low. In
most cases, a high setting can cause the audio electronics to distort the
sound.

Table of Contents