<Doc_TEC><Doc_503712400><Rel_B><Lang_EN>
Page 58 av 64
7.2.1 Setting dosages
This must only be done by authorized personnel.
The pumps in the various systems cannot be adjusted. All adjustments are done by
varying the running time of the pump during the cleaning program. Adjustment is done
in the service program.
The machine may be tted with the following dosing systems:
Dosing system Default Setting range Line
Descaling agent 6 0-99 seconds 8
Rinse-aid 0 0-99 seconds 9
Process agent 23 0-99 seconds 10
7.3 Replacing a hose in the dosing pump
Wear and tear in combination with chemicals can accelerate deterioration of the hose.
All changes to the hose’s condition can alter the amount of detergent/descaler added and
thereby have a negative impact on the process. Replace the hose(s) regularly.
This must only be done by authorized personnel.
Make sure that the machine’s power is switched off before starting work.
• Remove the cover of the pump.
• Release one of the hose xings and pull the hose upwards while spinning the
impeller by hand at the same time.
• When the hose is free from the impeller: install the new hose.
• Secure one of the hose xings and press down the hose while spinning the impeller
by hand at the same time.
• When the hose is down in the pump housing, put back the other hose xing as well
and ret the cover.
NOTE: Do not take out the impeller!
7.4 Check the empty container alarm regarding function/sealing.
In the worst case, a missed alarm signal for an empty container can result in the process
running without the cleaning and/or descaling agent being added, with dirty items as a
result.
Clean the empty container alarm and replace it regularly.
7.5 Checking that the door to the dishwasher closes properly (option)
Check the door spring, so that it closes properly.
Hose fixing
Impeller
Hose
To Next Page
Loading...
Need help?
General
