Page 7 of 27
NOTE!
Manufacturer declares, that electrical safety tests, as described in EN
61010, Annex F (F.2 to F.4), are being performed on 100% of manufac-
tured sterilizers.
NOTE!
Using the sterilizer in a manner not specifi ed by the manufacturer may
have signifi cant impact at the sterilizer’s safety of use.
VERIFICATION
VALIDATION
COPYRIGHT
WARRANTY
The warranty for the equipment is handled by Getinge’s representative in each
country. For warranty issues, please contact your local Getinge representative.
If indicators are used to verify the process, use only certifi ed products, fulfi lling
relevant standards. In our test runs we have used Getinge Assured indicators.
If the sterilizer is to be used for sterilization of medical instruments, the
sterilizer must be validated pursuant to ISO 17665-1 before commissioning
and validated state must be maintained according to this standard throught
lifecycle of sterilizer. If the products that are being sterilized are to be CE-
labeled, the MDD directive must be followed.
Instalation qualifi cation and operational qualifi cation can be performed using
information included in Annex D EN 285.
C
opyright ©2018 Getinge IC Production Poland Sp. z o.o.. All rights
reserved.
All technical documentation provided by
Getinge IC Production Poland Sp.
z o.o. is copyright protected and the property of Getinge IC Production Po-
land Sp. z o.o..This publication may be downloaded from Getinge’s offi cial
website: www.getinge.com
The technical documentation is delivered as is. The documentation may
contain printing errors, technical errors or other errors.
Getinge IC Production
Poland Sp. z o.o. reserves the right to make alterations without prior notice.
No part of this publication may be copied without the expressed permission
of
Getinge IC Production Poland Sp. z o.o..
LIFE TIME
Expected life time of HS33 sterilizer is 12000 cycles, corresponding to 10 years.
To Next Page
Loading...
