Page 8 of 27
DISPOSAL
WRAPPING MATERIAL
Wrapping material for the load must comply to norms and regulations to secure
a perfect result. Applicable norms are: EN ISO 11607.
This product contains electrical and electronic components.
The electronics must be handled by an authorized recycling company.
When scrapping, the sterilizer must be sorted at the source pursuant to the
requirements of the WEEE directive (2012/19/EU). If you have questions,
contact your dealer.
This product consists of (percentage/weight)
• 40 % stainless steel
• 35 % aluminum
• 8 % iron
• 6 % brass
• 6 % elektronics
• 3 % plastic
• 2 % copper
Packaging disposal must be carried out in accordance with the law of
destination country.
Setup must be carried out by technicians with documented experience.
• The sterilizer must be installed and located indoor.
• Firm surface that will not be damaged by any unintentional water spillage
or leakage and withstand at least 420 kg.
• Maximum ambient temperature of +2-35 °C.
• Relative, non-condensing, humidity of maximum 95 %.
• Feed water temperature maximum 20 °C.
• Feed water hardness, maximum 4 dH, for steam production 30 µS.
• Max installation altitude is 2000 m.
• The sterilizer is constructed according to installation category 2 (CAT II).
• Minimum permitted spacing between the sterilizer and patient is 1.5 m.
• The sterilizer can work in pollution degree 2 environment.
!
INSTALLATION - GENERAL
The supply wiring shall have a non-disconnectable protective ground conductor
from the switch to the sterilizer’s ground terminal.
MDD 93/42/EEC - 0123: TÜV SÜD Product Service GmbH, Ridlerstraße 65,
80339 München, Germany
Getinge IC Production Poland Sp. z o.o.
ul. Szkolna 30, 62-064 Plewiska, Poland
MANUFACTURER
To Next Page
Loading...
