GFI FaxMaker Appendix 1: Microsoft Exchange 2000/2003 Connector | 41
8 Appendix 1: Microsoft Exchange 2000/2003 Connector
The SMTP connector is a standard Microsoft Exchange SMTP connector, configured
to route to GFI FaxMaker server all emails addressed to faxmaker.com, smsmaker.com,
fax: and sms:.
Access the connector from:
1. Launch Exchange System Manager and expand Connectors node.
2. Right click FaxMaker SMTP connector and select Properties.
8.1 Creating the connector automatically
GFI FaxMaker installed on Microsoft Exchange Server
During installation, GFI FaxMaker automatically configures a Microsoft Exchange connector
to allow processing of faxes and SMS.
No further configuration is required post-installation.
GFI FaxMaker installed on a separate machine
To configure connector when installing GFI FaxMaker on a separate machine than Microsoft
Exchange 2000/2003 server:
1. Run the GFI FaxMaker setup on the Microsoft Exchange Hub Transport server.
2. When choosing the components to install, disable GFI FaxMaker Fax Server and select
Exchange 2000/2003/2007/2010 SMTP connector.
3. In the next screen, specify the IP address or server name of the GFI FaxMaker server.
4. Proceed with installation.
For more information, refer to Installation procedure chapter in this manual.
8.2 Creating the connector manually
1. From Microsoft Exchange server, launch Exchange System Manager and right-click
Connectors node.
2. Select New ► SMTP Connector.
To Next Page
Loading...