EasyManua.ls Logo

Gibertini E50S/3 - 6.3.9 Anti-theft encoding

Gibertini E50S/3
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Semi
-
Page 16 of 38
NOTE
If a power failure occurs, the timer continues running. If this does not happen, this indicates that the
instrument’s backup battery has expired and has to be replaced by GIBERTINI Customer Service.
6.3.9 Anti-theft encoding
The balance can be protected against theft by using a freely selectable, four-digit numerical code:
If the anti-theft code is deactivated, the instrument can be re-started and operated after a power outage
without having to enter a code.
If the anti-theft code is activated, the instrument requires the code to be input after each power outage.
If the code is entered incorrectly, the instrument is locked.
If the instrument is locked, it must first be disconnected from the power supply, then reconnected and
unlocked by entering the correct code.
After seven consecutive incorrect entries, the display reads “NO ACCESS, CALL SERVICE”. In this case
only a GIBERTINI service engineer can unlock the instrument again.
NOTE
The anti-theft encoding is deactivated in the factory settings.
The preprogrammed code set at the factory is: 8 9 3 7
This code is the same in all instruments. Therefore, for security reasons, enter your own code. Keep
your own code in a safe place.
THEFTCODE
THEFTCODE - - - -
THEFT-PROTECTION ON/OFF
Switch encoding on/off
NEW CODE - - - -
Enter a new code
Procedure to activate the anti-theft encoding:
Display
Key
Step
- - - - - - - -
THEFTCODE
-
-
-
-
«»
Press repeatedly, until the “THEFTCODE” is displayed
- - - - - - - -
THEFTCODE
0
0 0 0
«»
The first digit in the code flashes and can be changed
- - - - - - - -
THEFTCODE
8
0 0 0
«»
Press repeatedly, until the first digit in the code is set
- - - - - - - -
THEFTCODE 8
0
0 0
«»
The second digit flashes.
The code can now be entered fully
- - - - - - - -
THEFTCODE 8 0 0 0
«»
Confirm the theft code
- - - - - - - -
THEFT
-
PROTECTION OFF
«»
The theft-protection can now be set
- - - - - - - -
THEFT
-
PROTECTION
OFF
«»
The display flashes, and the theft-protection can be
activated
- - - - - - - -
THEFT
-
PROTECTION
ON
«»
Activate the theft-protection
- - - - - - - -
THEFT
-
PROTECTION
ON
«»
Confirm the theft-protection