15
First steps
Gigaset SL400-SL400A / EN for IM-Nord / A31008-M2103-R201-3-SM19 / starting.fm / 01.02.2011
Version 4, 16.09.2005
First battery charge and discharge
The correct charge status can only be displayed if the battery is first fully charged
and discharged.
¤ Charge the handset in the charger for 3 hours.
¤ After charging, remove the handset from the base and only replace it when the
batteries are fully discharged.
Please note
Only place the handset in the designated charger.
Please note
u Each handset is registered with the base at the factory. You do not need to
register the handset again. If you wish to use your handset with a different
base or use further handsets with your base, you will need to register the
handset manually (
¢ page 63).
u After the initial battery charge and discharge, you may place your handset in
the base after every call.
u Always repeat the charging and discharging procedure if you remove the
battery from the handset and reinsert them.
u The battery may warm up during charging. This is not dangerous.
u After a while, the charge capacity of the battery will decrease for technical
reasons.
To Next Page
Loading...
