GILES FSH-2-PH - Page 55

45
Troubleshooting
FSH−2−PH
6.01 Troubleshooting Procedures − continued
Problem Probable Cause Corrective Action
Fryer will not powerup:
• [HOOD POWER] light ON
• [FILTER MISSING] light ON
• [FRYER POWER] light OFF
a. Baffle filter is missing or not
properly installed
Install filter / check positioning.
b. Charcoal filter is missing or not
properly installed
Install filter / check positioning.
c. Faulty filter switches. Test & replace as needed.
Fryer will not powerup:
• [HOOD POWER] light ON
• [FILTER MISSING] light OFFN
•
[FRYER POWER] light OFF
• No alarm sounding
a. Fire Suppression system is not
armed.
Contact Ansul service company.
b. Ansul switch is faulty Contact Ansul service company.
Fryer will not powerup:
•
[HOOD POWER] light ON
• Continuous (steady) tone alarm
sounding.
•
[FRYER POWER] light OFF
a. Baffle or charcoal filter clogged
Replace charcoal filter with new •
Clean baffle filter.
b. Hood exhaust outlet excessively
block
Clear of any obstructions.
c. Vacuum switch is out of
adjustment
Test & adjust vacuum switch.
d. Kinked or blocked vacuum line
Remove vacuum line kinks or
blockage.
e. Fan running slow or blades are
loaded with grease buildup.
Check voltage and inspect blower;
clean if needed
Fryer will not powerup:
•
[HOOD POWERED] light ON
• [WASH] light ON
• Intermittent (beeping) tone alarm
sounding.
• [FRYER POWER] light OFF
a. Excessive grease film built up on
collector fins; too dirty
Clean the EAC cell, Section 4.04.2.
b. EAC cell is not installed Install clean EAC cell.
c. EAC driver board is faulty
Test & replace EAC power supply if
needed.
d. Poor connection at contact
plate; dirty contacts, mis
alignment, faulty contacts.
Check cell position, clean contacts,
inspect contact plate & replace if
needed.
e. Ionizer wire(s) missing Replace missing wire(s)
Fryer is ON:
• [HOOD POWER] light ON
•
[CHECK] light ON
• No alarm sounding, but cell is NOT
cleaning air.
a. Ionizer wire broken & touching
chassis.
Replace ionizer wire.
b. Collector fins shorted to ground
by moisture.
Dry cell, determine cause of
moisture, cool air being drawn into
hood creating condensation.