Pedal Box Adjustments
16
Pedal Box Mount Locations:
• Ensure mounting bolts are torqued to 45Nm with 243 Loctite
(6mm hex key)
• 140mm: Front chassis – Master cylinder mounting face (A1)
• 158mm: Front chassis – Master cylinder mounting face (B1)
• 176mm: Front chassis – Master cylinder mounting face (A2)
• 194mm: Front chassis – Master cylinder mounting face (B2)
Pushrod Lengths:
• Throttle: 93mm
• Front Brakes: 84mm
• Rear Brakes 84mm
• Clutch: 75mm
Brake Bias:
• Factory setting: Front 56%
• Adjustment: 1 turn clockwise = +1.5% front bias
• To test bias:
• Cycle to warm up dashboard page
• Hold brake pressure and check bias on screen
• Adjust to desired value in small increments to prevent the cable
binding
• 1.5 – 2mm play in brake balance bar is normal
Pedal Locations:
• Throttle pedal is fixed
• Brake pedal is 15mm closer to driver compared to throttle
• Pedal pad locations adjustable. Torque to 18Nm with Copper slip
(5mm hex key)
• Throttle side guard adjustable. Torque to 18Nm with 243 Loctite
(4mm hex key + 7mm spanner)
To Next Page
