User Manual
● Use the original box to repackage the inverter, seal with adhesive tape with the desiccant inside the
box.
● Store the inverter in a clean and dry place, free of dust and dirt. The storage temperature must be
between 40~176°F and humidity should be between 0 to 95%, non-condensing.
● Do not stack more than two (2) inverters high on a single pallet.
● Keep the box(es) away from corrosive materials to avoid damage to the inverter enclosure.
● Inspect the packaging regularly. If packing is damaged (wet, pest damages, etc.), repackage the
inverter immediately.
● Store inverters on a flat, hard surface -- not inclined or upside down.
● After 100 days of storage, the inverter and carton must be inspected for physical damage before
installing. If stored for more than 1 year, the inverter needs to be fully examined and tested by
qualified service or electrical personnel before using.
● Restarting after a long period of non-use requires the equipment be inspected and, in some cases,
the removal of oxidation and dust that has settled inside the equipment will be required.
1.7 Storage
If the inverter is not installed immediately, storage instructions and environmental conditions are below:
1.8 Notice for Disposal
This product shall not be disposed of with household waste. They should
be segregated and brought to an appropriate collection point to enable
recycling and avoid potential impacts on the environment and human health.
Local rules in waste management shall be respected .
1. Introduction
8
SAVE THESE INSTRUCTIONS – This manual contains important instructions for Models
Solis-185K-EHV-5G-US, Solis-255K-EHV-5G-US, Solis-185K-EHV-5G-US-PLUS and
Solis-255K-EHV-5G-US-PLUS, that shall be followed during installation and maintenance
of the inverter.
DO NOTSTACK
MORE THAN HIGH
2
To Next Page
Loading...
Need help?
General
