GME CP30 - General Operation; Operation of the Keys

CP30 INSTRUCTION MANUAL
14
GENERAL OPERATION
Please refer to the diagrams on the ‘Default Settings’ page for a general
description of the controls and keys.
Operation of the Keys
Where the instruction says Press you should briey press and release the key to
activate its feature. Where the instruction says Hold you should press and hold
the key for 2 seconds to activate its feature.
Key Beeps
If the beep option in your radio’s menu is enabled, a beep will be heard whenever
a key is pressed. A high beep indicates the key’s function has been activated
successfully. A rising two-tone beep indicates a function has been switched On
while a falling two-tone beep indicates the function has been switched O. A
falling two-tone beep will also be heard when a key’s function cannot be selected.
NOTE: If Channel Announce is switched On, beeps will not be heard when rotating
the Channel knob or pressing the keys. Instead, a voice will be heard
announcing the channel.
Function Key
Most keys have multiple functions that are printed on the key in white and red.
The primary key functions are printed in white. There are usually two operations
related to each primary function and these can be accessed either by briey
pressing the key or by holding the key.
To access the secondary functions printed in Red you need to rst press the
MENU
F
key. ‘F’ will be displayed to indicate you are in Function mode. While ‘F’ is
displayed, press the desired Red key within 10 seconds to activate that function.