GME CP30 - Receiving a Selcall

55
CP30 INSTRUCTION MANUAL
4. To send the displayed Ident without changes:
i. Hold the
CALL
LOCK
key. The ident will be sent.
5. To edit the displayed Ident before sending:
i. Rotate the Channel Selector knob or press the keys to
select the desired number in the ashing digit position.
ii. Press
MENU
F
to advance to the next digit position.
iii. Repeat steps i & ii to change any required digits.
iv. When the desired Ident is displayed, hold the
CALL
LOCK
key to send.
Call Acknowledge
If your SelCall transmission was successful, the radio you called should respond
with a call-acknowledge transmission which will be heard in your radio as two
quick beeps. This will conrm to you that the radio you called is now alerting its
user to your signal. If the call-acknowledge is not received the other radio may be
out of range or on a dierent channel.
Receiving a SelCall
When someone calls your radio using SelCall, your radio will beep to alert you
to the call and the Ident or Name of the caller will be displayed on the LCD. In
addition, it will cancel the quiet mode (if selected). The radio will remain in this
state until you cancel the alarm.
Cancelling the Alarm
To cancel the alarm and clear the display, press the
MENU
F
key. You can now have
a normal conversation on the channel. When you have nished, briey press the
QUIET
PWR
key if you wish to return to quiet operation.
If you wish to ignore the alarm and return directly to quiet mode, briey press
the
QUIET
PWR
key. The alarm will be cancelled and the channel will return to quiet
operation.
Displaying the Incoming SelCall Contact
If the incoming SelCall is from a person in your contact list, you can choose to
display either their Ident or their name on the LCD. Displaying their name makes it
much easier to identify them from other contacts.