GME CP30 - Beeps; Channel Announce

CP30 INSTRUCTION MANUAL
34
Beeps
The CP30 uses beeps to provide audible feedback whenever a key is pressed or to
notify you of various alarms and timers.
The Beep setting can be adjusted in the menu.
To Adjust the Beep Setting:
1. Hold the
MENU
F
key to access the menu. The last selected menu item
will be displayed.
2. Rotate the Channel Selector knob or press the keys until
BEEP is displayed.
3. Press the
MENU
F
key.
Channel Announce
Channel Announce provides an audible voice that speaks the channel number
whenever a channel is selected. Channel Announce has two settings: ON or OFF.
When Channel Announce is set to ON, the channel number will be announced
whenever a channel is selected.
NOTE: If Key Beeps are switched ON, Channel Announcements will override the
key beeps when changing channels.
To Activate Channel Announce:
1. Hold the
MENU
F
key to access the menu. The last selected menu item
will be displayed.
2. Rotate the Channel Selector knob or press the keys until CH
ANN is displayed.
3. Press the
MENU
F
key.
4. Rotate the Channel Selector knob or press the keys to select
ON or OFF.
5. When the desired setting is displayed, press the
MENU
F
key to exit the
menu or wait a few seconds for the menu to time-out.